Gas Line Repair in Atwater Village, Los Angeles

Plumbing Tips

Gas Line Jobs in Atwater Village Homes

The houses here are close in age and close in layout, so the gas work falls into a few patterns. All of them come under our gas line services.

• Original pipe under a 1920s bungalow — threaded steel that has rusted at the fittings. When one joint leaks, the joints beside it are the same age, so we test the whole run and tell you plainly whether a section or the full line should be replaced.

• A kitchen remodel — moving the range or stepping up to a larger cooktop means a new or extended line sized for the appliance. Los Angeles also requires a seismic or excess-flow gas shutoff valve once a building permit passes the valuation the city sets, so we raise it at the estimate instead of at final inspection.

• A garage conversion or backyard unit — a second kitchen and water heater at the back of the lot need their own line from the meter, sized for the added load. We run it, test it and leave any change to the meter itself to SoCalGas.

Which office handles gas permits for Atwater Village?

The Los Angeles Department of Building and Safety. Atwater Village is part of the City of Los Angeles, so the permit comes from LADBS and from no other city, however close the city line is. Gas piping falls under a plumbing permit there and is inspected before it is put into service. We can pull the LADBS permit for you, with our administrative fee added to the city’s charge, or you can pull it as the owner.

SoCalGas shut off my gas after a leak check. What now?

The piping past the meter belongs to the property, so the repair is the owner’s to arrange, and it is the part we do. We locate the leak, repair or replace the pipe, pressure test it and, where a permit applies, meet the inspector. Once the line holds, the gas can be turned back on and the appliances relit.